Porsche 962 C restored to its original condition down to the last detail

Hans-Joachim Stuck has had to wait almost 35 years for a reunion with the fully refurbished 962 C and its first rollout. So the surprise was all the greater when the silk cloth was drawn back to reveal the vehicle at the Weissach Development Centre.

The racing car from the Porsche Heritage and Museum department has been restored to its original 1987 condition over the past year and a half. “It feels like coming home,” smiles Stuck, stroking the car’s left wing. The racing driver says he has nothing but fond memories of the victorious car with the racing number 17. “By arranging this reunion after more than three decades, we have not only surprised Hans-Joachim Stuck, we have also taken a little journey through time. The history of the motorsport story surrounding the 962 C is unique,” says Achim Stejskal, Head of Porsche Heritage and Museum.

At the Weissach Development Centre, where the vehicle was first built and now has been restored to its original condition, Stuck also meets his race engineer of the time, Norbert Singer, and designer Rob Powell, the man responsible for the car’s black, yellow and red livery.

Hans-Joachim Stuck, 962 C, 2021, Porsche AG
Hans-Joachim Stuck and his race car, the 962 C.
Norbert Singer 962 C, 2021, Porsche AG
Norbert Singer on 962 C.
Armin Burger, 962 C, 2021, Porsche AG
Armin Burger next to the 962 C in Weissach.

It is 35 years since the now 70-year-old won Germany’s prestigious and fiercely contested ADAC Würth Supercup. During the inaugural series for Group C sports car prototypes, he tested the then-new Porsche dual clutch transmission (PDK) at racing speed. The vehicle’s appearance changed before the second race, the Norisring 200 miles, when Shell came on board as a sponsor. Porsche also competed in yellow and red the following year and Stuck worked hard to successfully defend his Supercup title. This 962 C then began its second life as a test car in the aerodynamics department at Weissach, later serving as a reference vehicle for the sports car manufacturer’s corporate collection.

Hans-Joachim Stuck, 962 C, Supercup, Norisring, 1987, Porsche AG
Hans-Joachim Stuck on Porsche 962 C in the Supercup at the Norisring in 1987, finishing 3rd.
962 C with Hans-Joachim Stuck as driver, 1987, Supercup, Porsche AG
1987, Supercup, 962 C with PDK with Hans-Joachim Stuck as driver.
962 C, ADAC Würth Supercup, Nürburgring, 1988, Porsche AG
The Porsche 962 C at the ADAC Würth Supercup at the Nürburgring in 1988.

Armin Burger and Traugott Brecht from Historic Motorsport were jointly responsible for the racing car’s rebuild. “We kept passing this car in the warehouse. Then, about a year and a half ago, we decided to get it out of there, transfer it to Weissach and start working on it,” he Burger. He and his team had to rebuild many parts because they were long gone. “The cooperation with the other departments from Porsche was great. We found almost everything we needed within a radius of just 30 metres,” says Burger. At the very beginning of the reconstruction work, he invited Powell and Singer into the historic motorsport workshop.

Rob Powell, Armin Burger, Norbert Singer and Traugott Brecht (f.l.t.r.), 2021, Porsche AG
Rob Powell, Armin Burger, Norbert Singer and Berthold Brecht (f.l.t.r.).

“When you hear the right people talking by the vehicle, everything immediately becomes clear. We learned an incredible amount from two witnesses who were right there when it all happened,” he adds. The experts completely rebuilt the underbody, changed the arrangement of the radiators and made many other bodywork adjustments. Then they presented the Supercup championship car to European media at a journalists’ workshop at the Weissach Development Centre.

Armin Burger (left) and Traugott Brecht inspect the 962 C, 2021, Porsche AG
Armin Burger (left) and Traugott Brecht inspect the 962 C.
Traugott Brecht starts with the disassembly of the 962 C, 2021, Porsche AG
Traugott Brecht starts with the disassembly of the 962 C.
Disassembly and removal of the 962 C, workshop of historic motorsports, 2021, Porsche AG
It all started with the disassembly and removal of the 962 C in the workshop of historic motorsports.
962 C, 2021, Porsche AG
The 962 C broken down into its components.
Factory's own house foundry, 2021, Porsche AG
The cylinder heads for the 962 C were cast in the factory's own house foundry.
Porsche's own house foundry, 2021, Porsche AG
The cylinder heads were produced in Porsche's own house foundry.
The 962 C being pushed out of the paint shop, 2021, Porsche AG
The 962 C being pushed out of the paint shop.
962 C, 2021, Porsche AG
Ready painted: the 962 C race car.

Livery designer Powell brought along various thicknesses of tape, stencils and design sketches from 35 years earlier. “Stucki immediately liked the design of my first sketch,” he recalls. Stuck gives him an affirmative nod over the roof of the car while the designer tapes the lines and applies a stencil to the front headlight: “This is very important, for example, so that the painters can plan the cut-out correctly. By the way, I still think the colour combination of yellow and red looks modern,” says Powell, putting the rolls of tape over his arm, ready for the numerous questions from the press.

Rob Powell, Livery Designer, 962 C, 2021, Porsche AG
Rob Powell in front of the 962 C - before it gets its design dress put back on.
Rob Powell, Livery Designer, 962 C, 2021, Porsche AG
Three decades later, Rob Powell, the livery designer, is still responsible for the 962 C's design. Here, he uses tape to trace the lines.
Rob Powell, Livery Designer, 962 C, 2021, Porsche AG
Rob Powell emphasizes that it was very special for him to be able to work on the 962 C once again.
Rob Powell, Livery Designer, 962 C, 2021, Porsche AG
Rob Powell puts the finishing touches on the 962 C's decals.

Stuck, who was involved in the development of the car, also takes questions and waits for his turn to do the first laps on the run-in and test track. “I’m a big fan of the Porsche PDK dual-clutch transmission and proud that I was allowed to test it in the 962 back then. Being able to keep my hands on the steering wheel when changing gears at full throttle felt great right from the start,” he says. Today, PDK is available in every Porsche. A second surprise awaits Stuck just a few metres from the test area, when he discovers his red racing suit from the 80s and is delighted to find he still fits into it. “For me, the time with Porsche was the most successful of my entire career,” he says, putting on his white star-decorated helmet and climbing in. Unlike the basic model, the 962 C has a wheelbase that’s 120 millimetres longer and pedals that are mounted behind the forward-mounted front axle.

Hans-Joachim Stuck, 962 C, 2021, Porsche AG
Hans-Joachim Stuck back at the steering wheel of the 962 C.

“We gave Stucki a very warm welcome at Porsche. He was always one of the drivers whose feedback I could interpret accurately, like the data from a sensor,” reveals Singer, who first introduced an aluminium monocoque with the 956 Group C car and its direct descendent the 962, as well as the Ground Effect underbody. Stuck starts his first lap on the two-and-a-half-kilometre test track in Weissach and all the spectators fall silent as they watch the Group C racer. “The car automatically takes me on a journey back in time and brings back many fond memories. I will never forget the atmosphere at the race tracks,” smiles Singer.

962 C, 2021, Porsche AG
The rollout of the 962 C.
962 C, 2021, Porsche AG
On the run-in and test track in Weissach, the 962 C turns its first laps after completion.
962 C, 2021, Porsche AG
Back on the road: the 962 C.
962 C, 2021, Porsche AG
His first laps in Weissach.
962 C, 2021, Porsche AG
Made motorsport history: the 962 C.

The 962 C made its first public appearance a few weeks ago at the Porsche Museum’s digital Sound Night. It will make many more appearances over the coming year, with driving and presentation events planned for the upcoming ‘40 years of Group C’ anniversary. “The 962 C was one of the few cars I was allowed to drive on my own, without team-mates and with exactly the setup I wanted. You never forget a car like that,” Stuck concludes, promising: “In 2022, we’ll celebrate the 40th in style!”

Related Content

Out of the box: photography by René Staud
History

Out of the box: photography by René Staud

There’s hardly a Porsche model left that hasn’t been photographed by René Staud, whose studio in the German town of Leonberg is the catwalk of the car industry. And while many photographic studios have disappeared in the wake of digitalization, Staud Studios continues to boom.